Friday, September 9, 2011

Freebie for mid gaugers

I was playing around with this nice sock yarn and decided that the LK-ers should have socks too - I thought they turned out pretty good - they are a little heavier (thicker) than I would wear with shoes but they are nice to wear around the house insteads of slippers or to wear with sport sandals - and there are a lot of good techniques for beginners! Try them out!
LK150 Socks
Ankle sock, knit flat, with heel and toe shortrowed. Stitches are grafted over top of toe. Seamed on one side to make a neat, one piece sock.
MACHINE: 6.5mm flat bed, sample made on Silver Reed LK150. 
Level - Beginner
YARN: Plymouth Yarns, Happy Feet DK,
90% superwash wool, 10% nylon; 100g/262 yds.
GAUGE: Stockinette, T3, 22 sts and 35 rows to 10 cm/4 inches.
SIZE: Ladies 7.5, med-wide foot. Adjust as necessary for your correct sizing.
LEFT FOOT
1. 26-0-26 n’s. Cast on waste yarn. T3, knit several rows, ending carriage at right. Ravel cord, K1R.
2. RC000. MC, hold 24" tail (use to seam side later), K19R, ending CAR.
3. Shape heel. Set to hold - russell levers both to l. Bring all left of 0 to D (hold position). RC000. Working on needles at right of 0 only, at carriage side, bring 1 needle to hold, K1R, 16X to 10 needles in work. RC016.
4. Reverse shaping. At side opposite carriage, return 1 needle to C (upper working position), K1R, 16X, ending CAR. RC032.
5. Cancel hold by returning russell levers to ll. Reset RC000. At centre, pick up heel stitch (purl bump of row below) from #1 left ( the held stitch) and hang on #1 right to fill in hole from shortrowing. K1R. All needles back in work. Knit to RC050 (or desired length), ending CAR.
6. Remove left side on waste yarn: set to hold. Remove MC and set aside without cutting. Place right of 0 to hold. Thread up waste yarn and K6-8R on left side and drop from machine.
7. Place carriage at right. Rethread MC and shape toe by repeating step 3 and 4. Measure out MC 4X width of needles in work to leave tail of MC (to graft toe) and remove on waste yarn.
To finish top with stockinette roll: rehang cast-on side, purl side facing. T2, K14R. T9, K1R. Chain off stitches.
To finish top with 1X1 rib: rehang cast-on side with knit side facing, have an uneven number of stitches. T3, K14R. T9, K1R. Drop every other stitch for 15 rows -down to the beginning of the knit stitches and reform with latch tool, then chain off - this will make a ribwise cast-off.
Make sock for right foot, opposite to above, exchanging right and left, so seams face each other on inside of foot.
Graft toe stitches.
Try my modified mattress stitch to seam sock. This makes a very neat, flat, almost invisible seam with no ridge inside. Thread yarn into bodkin. Working from knit side, go into half outside edge on one side, across to corresponding row on opposite side; move up one row on same side; across into stitch one row above previous stitch on same side; up one row on same side, across, etc. Or another way to put it, go from the knot on one side to the loop on opposite, up into the knot on same side, across to loop, etc.
To adjust for size, use one or two less stitches each side for a narrower width and  add/subtract 3 to 4 rows per half size in length before making the toe part.

2 comments:

My One and Only said...

So cool, as always! Thank you

Chris said...

The weather here is beginning to cool and I was just thinking of adding more socks. This is a perfect MK sock to try my first on. Thank you!